Mold Making Guide
This guide presents a method of making a simple single cavity mold.
|
Go >> |
Surface Preparation Guide
For most applications, good bonding may be obtained by the following surface preparation:
|
 |
Conformal Coating Application Information - C-115
This technical bulletin is designed to give the user suggestions to get the best results when using CONATHANE® conformal coatings for printed circuit applications. Application of CONATHANE® conformal coatings is very dependent on process controls by the user to gain the ultimate performance from the cured film. Several factors are involved to gain this final high quality of performance.
|
|
Minimizing Gas Bubbles
Guidelines For Minimizing The Introduction Of Gas Bubbles In A Polyurethane System
|
|
Hardness Value Chart
The hardness values listed are approximate and should only be used as a durometer selection guide.
|
|
Product Selection Form
Product Selection Of Adhesives/Sealants – Encapsulants – Coatings Tooling Resins – Elastomers
|
|
Troubleshooting Guide
Identify problems and locate quick solutions! |
|
